Steam exhaust boiler with a steam production of 500 kg hrs and thermal oil heaters which is better? Which is more energy-efficient? Steam boilers and thermal oil heaters, which is more fuel cost savings? At the same power (represented with evaporation) for comparing the boiler, HTF medium because of the high temperature, so that the temperature of the steam exhaust gas temperature than the exhaust gas with a higher heating power of the boiler, the exhaust gas temperature directly affects Thermal efficiency. That same power (represented with evaporation) conditions, the efficiency is not high efficiency oil boiler steam boiler. In fact, now you finally choose what kind of boiler is required to rely on the temperature of your decision. If you ask a medium temperature to 300 degrees, you can only choose oil furnace; if you think there is a live medium temperature of 180 degrees is enough to use, it is recommended that you choose a steam boiler, because it is more energy-efficient with conditions). These are the kind of steam boilers and thermal oil heaters and today we analyze all the information of more energy-efficient, and the above information indicates that the steam boiler more energy saving, more fuel-efficient.

Our company in the choice of exhaust boiler with a steam production of 500 kg hr products, attaches great importance to the quality of emissions and steam boilers, boiler low emissions of pollutants party provides fast, good steam quality is superior boiler products. --customer feedback

Matters needing attention in loading and installation of Gas-fired Steam Boiler

Gas-fired steam boilers are a very wide range of special equipment, usually built in boiler rooms. However, in the process of loading and installation, some problems must be paid attention to, otherwise it may cause a certain degree of economic loss.

1. Pay attention to the following matters during the loading and unloading and handling of gas-fired boilers: the lifting capacity of the lifting equipment should match the weight of the lifting boiler. The lifting lug on the boiler with the lifting lugs that cannot be used for lifting can not be used for lifting. The length of the steel cord should be reasonably selected to avoid the scratching of the furnace due to the improper length of the steel cord. The boiler must be protected from any damage during handling and handling.

2. Reserves for maintenance space When installing boilers, ensure that there is sufficient maintenance space around the boiler.

3. Setting and precautions for the base and base of the gas steam boiler The boiler body must be installed on the basis of 100-150mm above the floor of the boiler room. It must be confirmed with the technical personnel of the boiler manufacturing company in advance and constructed according to the basic drawings. The anchor bolts must be reserved on the foundation. The foundation shall be capable of withstanding the maximum weight of the boiler and the amount of water it holds. When installing the base, you must first position it. After positioning, adjust to the same length of the two diagonals of the base, and then tighten all the fixing bolts. The installation of the base is carried out with reference to the reference line.

4, general precautions Be careful not to tilt and impact the boiler and accessories too much. No combustibles can be placed around the boiler. Do not use oil and water to smother the boiler. The boiler should normally be installed in a separate boiler room. The new gas-fired boiler room should not be connected to the house. The boiler room shall not be connected to Class A, Class B and Category C fire hazard rooms using flammable liquids. If connected to other production plants, the application firewall is separated.

The main data processing means is automatically shutdown when the exhaust boiler with a steam production of 500 kg hr pressure is too high, the combustion system will stop working; operating power may also be changed, single-stage or two-stage combustor; can adjust the amount of oil (or gas) to achieve proportional control, whereby depending on the steam pressure adjusting load operation of the burner, to ensure safe operation of the boiler.